April 2019 No.88
Featured Topic
Our Endeavor in the Automotive Business to Achieve VISION 2022
Our Endeavor in the Automotive Business to Achieve VISION 2022
- Prefatory Note（
2.1 KB）
Approaches to Future In-Vehicle Networks
- Future In-Vehicle Electronic Platform（2.1 MB）
- Development for Expansion of Aluminum Wiring Harness（2.4 MB）
- Digital Twin Environment to Integrate Vehicle Simulation and Physical Verification（1.6 MB）
- Physical Layer Simulation Technology for Automotive Ethernet（1.8 MB）
Responses to Vehicle Electrification
- Wiring Harness and Connector for Electric and Hybrid Electric Vehicles - Pipe Shielded Wiring Harness, Power Cable, and Direct Connector -（2.0 MB）
- Reactor for Boost Converter for Electric and Hybrid Electric Vehicles（1.4 MB）
- Battery Wiring Module for Electric and Hybrid Electric Vehicles（1.0 MB）
- Automotive 48-Volt Converter（2.1 MB）
- Rectangular Magnet Wire for Electric and Hybrid Electric Inverter-Drive Motors（1.3 MB）
- CHAdeMO-Conformity High-Power Charger Connector Assembly for Over 100 kWClass EV Charge（2.3 MB）
- Battery State Estimation System for Automobiles（1.3 MB）
- TAB-Lead for Automotive Lithium-ion Batteries（1.0 MB）
- High Current SiC Transistors for Automotive Applications（1.2 MB）
Technologies Supporting Connected Vehicles
- Traffic Management System toward Connected and Automated Vehicles Era（871 KB）
- Intrusion Detection System for In-Vehicle Networks（2.8 MB）
- A Proposal of the Device Disabler for Controller Area Network（1.6 MB）
- Evaluation of 700 MHz Band Radio Resource Allocation Algorithm and Installation Operation of Roadside Units（1.9 MB）
- 24-GHz Band Radar for Driving Safety Support Systems（1.4 MB）
- Millimeter-Wave Automotive Antenna Using Low-Loss Fluoro-resin Substrates（1.4 MB）
- Virtual Power Plants Using Electric Vehicle and Plug-in Hybrid Vehicle Batteries（928 KB）
Next Stages of In-Vehicle Product Development
- Highly Heat-Resistant Flexible Flat Cable for Automotive Applications（1.6 MB）
- In-Vehicle Application of Flexible FUREKI（1.1 MB）
- Features and Vehicle Application of Heat Resistant Die Cast Magnesium Alloy（2.9 MB）
- Noise, Vibration, and Harshness Analysis Technique Using a Full Vehicle Model（3.4 MB）
- Lightweight Filler Neck Hose for Reducing Environmental Load（1.6 MB）
- Improvement of Noise Absorbing Thermal Conductance “Magnetic Induction Foaming” for In-Vehicle Use（1.7 MB）
- Humidity-Aging Resistant Steel Cord（1.4 MB）
- Diamond-like Carbon Film for Bearing Parts and Its Mass Production Technology（1.3 MB）
Introduction of New Products and Techniques
Back number
- 2020
- 2019
- 2018
- 2017
- 2016
- 2015
- 2014
- 2013
- 2012
- 2011
- 2010
- 2009
- 2008
Copyright Notice
Copyright of the paper contained in SEI TECHNICAL REVIEW belongs to Sumitomo Electric Industries, Ltd.
The paper is to be used solely for private, reference purpose, and reproduction without the permission of the copyright holder is prohibited.
About PDF Documents
These documents are in the PDF format.
Adobe Reader is necessary so that you can read and print the PDF documents.
These documents are in the PDF format.
Adobe Reader is necessary so that you can read and print the PDF documents.
http://www.adobe.com/jp/products/acrobat/readstep2.html