Performing an Arc Test

  • Fusion splicer
  • User guide
  • Facebook
  • LinkedIn

December 17, 2018

Help Video for TYPE-72C/TYPE-82C

Help Video for TYPE-71M12

Help Video for TYPE-201eM4

Help Video for TYPE-201eVS

An arc test is not normally required in "AUTO" mode because the function which optimizes arc power is activated, except that there are extreme changes in operational environment.

TYPE-72C/82C

(1) Insert prepared fibres into the splicer.

(2) Ensure that the selected fibre type matches with the fibre inserted.

(3) Tap the "Arc Test" icon.

(4) Tap the "SET" icon.

(5) Tap the "SET" icon to start an arc test.

(6) When "Arc Power Too Strong", "Arc Power Too Weak", or "Arc Center" is displayed, re-do until test is successful.

If "Good arc state." is displayed, begin the fibre preparation procedure to perform a splice.

TYPE-71M12, TYPE-201eM4, TYPE-201eVS

(1) Insert prepared fibres into the splicer.

(2) Ensure that the selected fibre type matches with the fibre inserted.

(3) Tap the "Arc Test" icon.

(4) Tap the "Start" icon to start an arc test.

(5) Tap the "GO" icon to start an arc test.

(6) When "Arc Too Strong", "Arc Too Weak", or "Arc Center" is displayed, re-do until the test is successful.

If "Arc OK." is displayed, begin the fibre preparation procedure to perform a splice.

Fusion splicer